Output Channels - Alcad 912-MS Serie Manuel D'installation Et Programmation

22 - ENG
3.1 Unit supply
To supply the unit, it is necessary to connect every module to the MS-011
(cod. 9120029) support framework, which performs the mass
connection.
3.2 Audio and video input connection
The miniDIN connector located on the front of the modulator incorporates
audio/video inputs. To connect the audio and video source, you can use
cable CD-003 (cod. 9120098) Stero, with a Euroconnector connection to
miniDIN or cable CD-011 (code 9120079) Mono or CD-113 (cod.
9120094) Stereo, with RCA connection to miniDIN.
6 7 8
3 4 5
1 2
3.3 Placing 75 Ω Ω charges
Except for the PA amplifier test, make sure that all the remaining unused
inputs and outputs are charged with an RS-275 (code 9120011) charge
of 75 Ω.
3.4

Output channels

The vestigial sideband modulator BLV included in the modulators permits
using adjacent channels.
RF output channels that are adjacent to each other or adjacent to the earth
TV channels from legal re-emitters (both lower and higher channels) can
be programmed.
If the installation includes external units that use double sideband
modulators, the channels immediately below the ones used by those units
must be free.
3.5 Channels from other units
PA amplifiers include a EXT input extension for channels from other units.
The channels added so join the output channels of the MS unit.
Installation and programming manual
1
AUDIO R IN
2
AUDIO R OUT
3
AUDIO L IN / MONO
4
5
AUDIO GROUND
6
7
AUDIO L OUT / MONO
8
9
10
11
12
13
14
15
16
17
VIDEO GROUND
18
19
VIDEO IN
20
VIDEO OUT
Fig. 5 - Audio and video input connection
AUDIO GROUND
6 7 8
AUDIO L / MONO
3 4 5
1 2
AUDIO GROUND
VIDEO GROUND
AUDIO R
VIDEO