Zeck Audio d.a.i.sy Mode D'emploi page 14

1
2
3
4
5
6
7
26
owner´s manual
owner´s manual d.a.i.sy wireless system, © Zeck Audio 8/96
owner´s manual
Turning the transmitter on (3)
The transmitter unit becomes activated, when the on/off switch (3) is noticeably engaged
in the dotted position. After turning the unit on, the battery check LED (2) on the trans-
mitter will flash shortly while the 'RF receive' LED (10) on the receiver should become con-
tinuously lit.
Whenever the transmitter is turned on, it draws supply current from the battery and thus,
drains the battery, even if no sound is transmitted.
Battery check indicator (2)
If the transmitter has been supplied with a fresh battery, the battery check LED (2) will
flash up only once after turning the unit on. As the battery discharges, turning on the unit
will cause the LED to flash more often (up to 5 times), depending on the battery's charge
condition.
A continuously flashing LED indicates an almost discharged battery. In this situation, a
rechargeable storage battery will only last for about 10 minutes more, while a one-way
battery will continue working for approximately another 1.5 hours.
Carrier pouch
An artificial leather pouch is supplied with the transmitter, to anchor the unit to a guitar
strap or belt. Holes in the pouch allow access to all functional elements such as switch,
LED and the XLR socket. The transmitter pouch is fastened by pulling its strap around the
belt or guitar strap and closing it (see picture).
owner´s manual d.a.i.sy wireless system, © Zeck Audio 8/96
27