AFG KERMI WKS Instructions D'utilisation Et De Montage page 8

If a device without a connector is directly
tions: install an isolator in accordance with
the local provisions for mains disconnec-
tion.
Operate the device only with the approved
Store and transport the device only in the
protective packaging.
Complaint
Contact the supplier.
Disposal
Packaging and any parts that are not nee-
ded should be recycled or disposed of pro-
perly. Observe local regulations.
Technical features (see type plate)
Nominal voltage
Cable cross section
capacity
contact
Power consump-
tion in the stand-by
mode
Insulation type
Thermostat
Protection type
wall outlet
Protective areas in rooms with bath
or shower facilities (for installation
examples, see Fig. A)
According to national installation stan-
trical equipment may only be installed in
specific areas in rooms with bathtubs or
shower facilities.
Electrical equipment is permitted in the
rooms referred to above if it is protected by
Electric devices are to be installed such that
the switches and other control and/or regu-
8
or
Protection class II
installation
lation equipment cannot be touched by a
- person in the bathtub or the shower.
mostat WKS) may only be installed outside
the protective areas.
Note: the manufacturer does not approve
the installation of products in protective
Install the following products only in pro-
as:
–
–
Installation
Preparatory activities
Ensure that a outlet socket is there within
the reach of the cable of the heating ele-
ment.
Ensure that there is an additional outlet
A) at the location provided for inserting the
thermostat.
A line connection is necessary between the
two outlet sockets.
To install device inserts, it is advisable to use
outlet sockets with an installation depth
The outlet sockets must be freely accessible
and may not be in the projection surface of
the radiator.
Install radiator and heating element.
Install thermostat and wall outlet
Check the delivery for completeness and
Install thermostat according to Fig.
Electrical connection
-
The device may only be connected by an elec-
trical specialist.
-
-
.