General International DP2006 Manuel D'installation Et D'utilisation page 8

YOUR HANDS, SPINNINg ON THE TABLE,
shattering the tool, or being thrown. always support your work so it
won't shift or bind on the tool.
22. ALWAYS POSITION THE WORkPIECE AND BACkUP MATERIAL
(used beneath the workpiece) to contact the left side of the column.
Whenever possible, position the workpiece to contact the left side of
the column — if it is short or the table is tilted, clamp it solidly to the
table.
23. CLAMP OR BRACE WORkPIECE AgAINST COLUMN
to prevent rotation.
24. SUPPORT THE WORkPIECE FIRMLY WITH A CLAMP,
vise, or work table when drilling. Hold the workpiece firmly. Loss of
control of the workpiece can result in injury.
25. WHEN USINg A DRILL PRESS VISE,
always fasten it securely to the table.
26. PROPERLY SUPPORT LONg OR WIDE WORkPIECES.
if a workpiece overhangs the table so that it could fall or tip if not held,
clamp it to the table or provide auxiliary support(s). Loss of control of
the workpiece is dangerous.
27. SUPPORT ROUND WORk PROPERLY
use V blocks to prevent it from rolling.
28. USE THE RECOMMENDED SPINDLE SPEED
for the specific operation and workpiece material — check the label
inside the pulley cover for drilling information
29. kEEP PULLEY COVER CLOSED
when not making belt adjustments.
30. TO AVOID INjURY FROM THROWN WORk OR TOOL CONTACT,
do not perform layout, assembly, or setup work on the table while the
chuck is rotating.
31. USE ONLY ACCESSORIES DESIgNED FOR THIS DRILL PRESS
to avoid serious injury from thrown, broken parts or work pieces.
32. WHEN CUTTINg LARgE DIAMETER HOLES, CLAMP THE
WORkPIECE FIRMLY TO THE TABLE.
otherwise the cutter may grab and spin at high speed. use only one
piece, cup-type hole cutters. DO NOT use fly cutters or multi-part hole
cutters as they may come apart or become unbalanced in use.
33. ACCESSORIES MUST BE RATED FOR AT LEAST THE SPINDLE
SPEED SETTINg OF THE DRILL PRESS.
this drill press has 5 spindle speeds. check spindle speed setting of
the drill press based on pulley speed chart located inside the pulley
housing. ensure accessories used have a higher speed rating than the
current spindle speed setting of the drill press. accessories running
faster than rated speed can fly apart and cause injury.
34. DO NOT INSTALL OR USE DRILL BITS THAT ExCEED 7"
(18 cm) in length or extend 6" (15 cm) below the chuck jaws. They can
suddenly bend outward or break.
35. DO NOT USE WIRE WHEELS, ROUTER BITS, SHAPER CUTTERS,
CIRCLE (FLY) CUTTERS, OR ROTARY PLANERS
on this drill press.
36. AVOID AWkWARD OPERATIONS AND HAND POSITIONS.
a sudden slip could cause a hand to move into the bit.
37. NEVER PERFORM LAYOUT, ASSEMBLY, OR SET-UP WORk ON
THE TABLE
/work area when the machine is running. a sudden slip could cause a
hand or hair to move into the spinning bit or chuck. Severe injury can
result.
38. DO NOT gET DISTRACTED AND ALWAYS CONCENTRATE ON
WHAT YOU ARE DOINg.
use common sense. never operate the machine when you are tired,
sick, or under the influence of alcohol, or other drugs.
39. LOCk THE SWITCH IN THE "OFF" POSITION TO PREVENT
8