General International DP2006 Manuel D'installation Et D'utilisation page 13

BASE AND COLUMN
1. Place the base (A, fig 4 & 5) on the floor.
2. Place the column assembly, (C, fig 4 & 5) on the base with the column
support (B, fig 4 & 5) at the bottom, the rack collar (L, fig 4 & 5) at the
top and the rack (D, fig 4) running between them. Align the column
support holes with the base holes.
3. install the four 10 mm x 40 mm long hex head bolts through each
column support hole and tighten into the base with the wrench.
MOUNTINg
wARNING! Drill presses are by their design, very top-heavy and must
be securely fastened in place.
● Decide where the drill press will stand and fasten your drill press
through the mounting holes in the base to the floor with heavy duty
bolts, washers, and nuts.
● if concrete, the bolts will need appropriate concrete anchors. this will
prevent it from tipping over, sliding, or walking during operation.
TABLE
1. remove the rack collar from the top of the column by loosening the set
screw in it.
2. remove the rack.
3. If not already installed, insert the worm shaft (u, fig 6) through the center
hole of the table support (J, fig 6) and out through the crank handle hole
as shown at right. the worm shaft should extend outside the housing
about 1" (25 mm).
4. Insert the rack (D, fig 5) into the vertical groove of the table support.
Make sure the worm gear driven by the just-installed worm shaft on the
inside of the table support is engaged by the teeth of the rack.
5. Place the table support at the roughly the center of the rack.
6. slide this table support and rack assembly down together onto the
column. insert the bottom edge of the rack so that it rests inside the lip
of the column support.
7. Hold it in this position while you place the rack collar bevel-side-down
over the top edge of the rack.
8. tighten the set screw with a hex (allen) wrench, holding the rack in
position.
NOTE: Make sure there is enough clearance to allow the table to rotate
around the column, the rack collar sitting loosely over rack and square to
the column. Tighten the set screw only enough to keep collar in place, to
avoid column or collar damage.
9. Slide the table support crank handle (I, fig 4 & 5) onto the worm shaft
protruding from the side of the table support. Fasten it with the set
screw, making sure the set screw is aligned with the flat of the shaft and
as close to the table support as possible. tighten the set screw.
10. Place the table (H, fig 4 & 5) on the other end of the table support arm
(E, fig 4 & 5).
11. Tighten the table lock (G, fig 4 & 5).
12. orient the table support arm in the same direction as the base, and
tighten the table support lock (K, fig 4 & 5).
HEAD ASSEMBLY
CAUTION: The head assembly is heavy (about 55 lb. / 25 kg) and you
will require assistance from a second person.
1. Lift the drill press head assembly (f, fig 2) carefully and slide the
mounting hole of the drill press head over the top of the column. Be sure
the head is seated properly on the column.
wARNING! Be sure the base is securely fastened to the floor.
2. align the direction of the drill press head so that it matches the direction
of the base and the table.
u
J
fig 6
u
150325
13