General International DP2006 Manuel D'installation Et D'utilisation page 17

3. raise and lock the table at about 1" (2.5 cm) below the tip of the drill bit.
4. use a combination square placed on the table to check. the drill bit
should be parallel to the straight edge of the square.
5. Make any adjustment needed by loosening the table bevel lock bolt with
a wrench and tilting the table
6. tighten the bevel lock bolt.
DEPTh GAUGE AND STOP
● the depth gauge allows the operator to see depth of the travel of the
quill, spindle and drill bit while operating the tool.
● to stop the drill's downward travel at a consistent specific depth,
particularly for repeat drilling, set up the depth stop.
With the drill press turned off:
1. set the bottom edge of the lower nut (#1) even with the desired depth
setting marked on the scale.
2. check the depth. Lower the drill using the feed handles alongside the
workpiece until it hits the stop. compare it to the desired hole depth.
3. if oK, tighten nut #2 against nut #1 to lock the position.
4. the depth stop is now set and will provide repetitive holes of equal
depth.
5. nut #3 can also be brought into play to limit the upward retraction of the
bit.
6. after using the drill press at the set depth provided by the depth stop,
remember to return the stop to the top of its range.
150325
17