General International DP2006 Manuel D'installation Et D'utilisation page 19

DRILLINg
1. For safety, the switch cannot be turned on without the key.
2. to turn the drill press on, with the safety key inserted into the switch
housing, lift the switch upward to the ON (I) position (fig 10).
3. to turn the drill press off, press the switch back to the down
position (O, fig 10).
4. to lock the switch in the oFF (o) position, pull the yellow safety key
(X, fig 11) out of the switch. store the key in a safe place.
5. use the feed handles to push the drill bit slowly into the material.
Particularly in wood drilling, ease up on the pressure when nearing
the point where the drill bit is about to emerge on the other side of the
workpiece.
6. after drilling a hole, do not release the feed handle but restrain it lightly,
allowing the spring to raise spindle sleeve gently to its original position.
7. turn off the drill press.
8. switch off the laser.
9. switch off the work light.
wARNING! After switching off, never leave the machine unattended
until it has come to a complete stop.
wARNING! In case of any trouble or abnormal noise arising during this
operation, stop the motor at once, unplug the machine from the power
source and find out the cause. Do not resume until the problem has been
solved.
I
g 10
X
O
fig 11
150325
19