Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Clamp the chuck safety guard (O, fig 4 & 5) around the lower exposed
part of the quill tube. Do not over-tighten.
LASER BATTERIES
1. Locate the laser switch (W, fig 5) on the left side of the head assembly.
2. Press the tab located below the laser switch (fig 7) and raise the cover.
3. insert 2 "aa" batteries, oriented in the directions indicated.
4. close the switch cover.
CAUTION: Remove these batteries from the compartment when the
tool is to be stored without use for more than a few days. If left in, the
batteries may leak and damage the laser device. Damage from leaking
batteries is not covered under the warranty.
ADjUSTMENTS
wARNING! To reduce the risk of injury, keep pulley cover in place and
in proper working order when operating.
SPEED AND BELT ADjUSTMENT
SELECT THE SPEED
the material you are drilling into and the size of hole you are planning to
make should determine the speed at which you set the drill press. as a
rule of thumb, small drill bits require more speed than large drill bits and
soft materials require more speed than hard ones.
Speed range
2000 to 3100 rpm
3/8"
1400 to 2000 rpm
5/8"
1000 to 1400 rpm
7/8"
800 to 1000 rpm
1-1/4"
530 to 800 rpm
1-5/8"
* these speeds are only general guides and vary further according to the
particular material you are working with (the kind of wood, for instance),
the type of drill bit or cutter you are using, any lubricants you may use and
the quality of the cut desired.
1. select the speed by moving the belt to the appropriate pulleys. open the
belt / pulley cover (V, fig 4 & 5)
2. consult the belt position / speed diagram.
APPROXIMATE RECOMMENDED DRILLING SPEEDS*
Wood
Aluminum / zinc / Brass
9.5 mm
7/32"
16 mm
11/32"
22 mm
15/32"
31.75 mm
11/16"
41.4 mm
fig 7
Non-ferrous metals
Drill bit diameter
5.6 mm
8.75 mm
12 mm
17.5 mm
3/4"
19 mm
W
Iron & Steel
3/32"
2.4 mm
5/32"
4 mm
1/4"
6.4 mm
3/8"
9.5 mm
5/8"
16 mm
150325
15
Publicité
Table des Matières
