Troubleshooting - MAJORITY OAKINGTON+ Guide D'instructions

Troubleshooting

Observation
No sound
Buttons are not
working
FM: Static sound
DAB: Burbling/
intermittent cut-out
Sound is distorted
Desired station not
found
Display shows "No
Service"
Display is blank
Time and Date not
setting automatically
Other problems/
functional issues
32
Potential Cause/Solution
The station is not tuned in. Fine tune the station. The volume
is set to a low position. Increase the volume. Headphones
may be connected. Disconnect the headphones.
Turn off the unit and turn on after a few seconds. Please also
try unplugging/replugging the radio.
Signal reception is low. Adjust the aerial or move the unit to a
stronger signal location.
Re-scan stations and or/ a factory reset.
The volume is too high. Adjust the volume control.
Weak signal. Use the manual tune function and try
rescanning in a different area.
There is no DAB coverage in your area, or poor reception.
Adjust the position of the aerial, or move the unit to a
stronger signal location.
This may occur if the broadcaster changes the label of a
service or removes a label while tuned. The radio will try to
retune or perform a scan.
Go to DAB mode and this will automatically set once a scan
is performed. Alternatively, set in your 'Settings' and adjust
manually.
Please perform a factory reset of the radio in your settings.
EN