Table des Matières
Publicité
OPERATION
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately
after terminating cooking.
To select the functions of the hood just lightly touch and hold control.
T1.
Standby mode (the control panel off all functions disabled) / ON (control panel switched on)
Note: After about a minute of inactivity (suction and lights), the hood will automatically switch to standby.
T2.
ON/OFF lights
Press again to turn off the lights.
T3.
ON/OFF Automatic operation "AdaptTech"
The hood automatically sets the suction speed (power) to increase if the environmental conditions detected by the
hood sensor require it.
If there are no variations in the environmental conditions, after 10 minutes (if the hood is already in suction speed
(power) 1), the hood turns off.
Note: for a correct use of this function, fi rst perform the "Setting of the parameters for Automatic Operation" (see
corresponding paragraph).
Note: During automatic operation, if the user acts on the other functions that adjust the speed, auto ventilation func-
tion is switched off.
T4.
Manual selection of the suction speed (power):
L1: suction speed (power) 1
L2: suction speed (power) 2
L3: suction speed (power) 3
Press again to turn off the hood (OFF).
Note: manual selection excludes any other suction related set function.
T5.
ON/OFF Intensive suction speed (power) „POWER BOOST" (timed)
Note: After 5 minutes of operation the hood returns to its previous state.
T6.
ON/OFF operation mode "Refresh"
Every 50 minutes of inactivity, the suction speed (power 1 is turned on for 10 minutes.
T7.
ON/OFF Delayed switch off of the suction speed (power) (approx. 30 minutes
Note: this function is available for the speeds that can be selected with button T4.
T8.
Indicator and reset fi lter saturation
The button lights on automatically with steady light when it is necessary to perform the grease fi lter maintenance. The
button lights on automatically with fl ashing light when it is necessary to perform the charcoal fi lter maintenance.
After performing the maintenance, with the hood off and the button active, press the button for more than 3 seconds
to perform the reset of the fi lter saturation indicator; repeat the operation if necessary (for ex., when both fi lters are
saturated).
Activation of the charcoal fi lter saturation indicator
The saturation indicator of the charcoal fi lter is normally disabled. To activate it, proceed in the following manner:
With the display on (ON) and the suction off (OFF), press simultaneously the buttons T7 and T8 for more than 3
seconds; the button T8 lights on with steady light for approx. 5 seconds, to indicate the activation.
To disable it, repeat the operation; the button T8 will fl ash for approx. 5 seconds to indicate the disabling.
32
Publicité
Table des Matières
