Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BATTERY CHARGER
SPECIFICATIONS
80V Li-ion Battery charger: 2901402
Input: 120VAC, 50Hz/60Hz, 5A
Output: 80VDC, 4A
W
e
g i
h
: t
3
3 .
b l
s
1 (
5 .
Class 2 Battery Charger
CHARGING PROCEDURE
The battery is not shipped fully charged. It is recommended to fully charge before first use
NOTE:
to ensure that maximum run time can be achieved. This lithium-ion battery will not develop a memory
and may be charged at any time.
Low voltage charging:
If the battery has been stored with little to no charge for a long period of time, the charger will go into
recovery mode, which will take 20 hrs to fully charge the battery. This will enhance the life of the battery.
Once it is fully charged, the next charge will return to standard charging.
A fully discharged battery pack will require approximately 30 minutes to fully charge from a discharged
state. Plug the charger into an AC power outlet.
Insert the battery into the charger.
•
This is a diagnostic charger. The Charger LED Lights will illuminate in specific order to communicate
h t
e
c
r u
e r
t n
b
t a
e t
y r
False defect note:
When the battery is inserted into the charger and the status LED blinks RED, remove the battery from
the charger for 1 minute, then reinsert. If the status LED blinks GREEN, then the battery is properly
charging. If the status LED is still blinking RED, remove the battery and unplug the charger for 1 minute.
After 1 minute, plug in the charger and reinsert the battery. If the status LED blinks GREEN, then the
battery is properly charging. If the status LED is still blinking RED, the battery is defective and needs to
be replaced.
k
) g
s
a t
u t
. s
T
h
e
y
a
e r
a
s
o f
o l l
w
: s
Charging
LED STATUS
Blinking Green
Solid Green
Solid Red
Blinking Red
4
Fully
Over
Charged
Temperature
DESCRIPTION
Charging
Fully Charged
Over Temperature
Charging Fault
Charging
Fault
Publicité
Table des Matières
