Battery Charger; Charging Procedure - GreenWorks CK24B220 Guide D'utilisation

BATTERY CHARGER

SPECIFICATIONS
24V Lithium-ion battery charger
Model: 2903102
Input: 100-240 V AC 50 / 60 Hz, 1.5 A
Output: 24V DC 3.0 A
Class 2 Battery Charger

CHARGING PROCEDURE

NOTE: The battery is not shipped fully charged. It is recommended to fully charge before first use
to ensure that maximum run time can be achieved. This lithium-ion battery will not develop a memory
and may be charged at any time.
1. Plug the charger into an AC power outlet.
2. Insert the battery pack (1) into the charger (2).
This is a diagnostic charger. The Charger LED Lights (3) will illuminate in specific order to
communicate the current battery status. They are as follows:
2
3
CHARGING PROCEDURE----DO NOT REMOVE
BATTERY IS CHARGING
FULLY CHARGED
BATTERY IS TOO WARM
APPROX. 30 MINUTES TO ALLOW TO COOL)
NO BATTERY PRESENT
DEFECTIVE BATTERY
MANUAL)
When the red indictor flickers, pull out the battery from the charger and insert again within 2
NOTE:
hours. If the indictor shows charging, that means the battery is good. After 2 hours, please pull out
the battery and also pull out the AC power plug of the charger for 1 minute, and then insert the
AC power plug and the battery again. If the indictor shows charging, that means the battery is good.
If not, the battery needs to be changed.
(REMOVE FOR
(REFER TO OWNERS
4
1
RED RED
RED GREEN
RED ORANGE
RED OFF
RED
RED BLINKING