Important Safety Instructions - GreenWorks CK24B220 Guide D'utilisation

BATTERY CHARGER

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS - DANGER: TO REDUCE RISK
1.
OF FIRE OR ELECTRICSHOCK CAREFULLY FOLLOW THESE
INSTRUCTIONS.
2 . Confirm the voltage in each country before using the charger.
3 . If the sharp of the plug does not fit the power outlet, use an attachment plug adaptor of the proper
configuration for the power outlet.
C A U T I O N
1. Risk of Electric Shock.
2. Dry location use only.
3. FOR INDOOR USE ON
4. Store indoors, and do not expose to rain or water, avoid direct sunshine.
5. CHARGE ONLY GREENWORKS RECHARGEABLE LI-ION BATTERY LB24A210, OTHER
TYPES OF BATTERIES MAY BURST CAUSING PERSONAL INJURY AND DAMAGE.
6. Be sure voltage selector is in correct voltage position before plugging in.
7. For connection to a supply not in the U.S.A., use an attachment plug adapter of the proper
configuration for the power outlet, if needed.
8. Do not mix old and new batteries and do not mix alkaline, standard (carbon-zinc) or rechargeable
(ni-cad, ni-mh, etc.) batteries.
9. This power unit is intended to be correctly orientated in a vertical or floor mount position.
10. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
W A R N I N G
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
- NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and the receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
LY
5