Unpacking And Assembly - EarthQuake MC43 Manuel De L'utilisateur

HARDWARE CHART
(Use this as a size guide for the hardware in the Unpacking
and Assembly section)
4640
T-handle Nuts
Qty 4

UNPACKING AND ASSEMBLY

Unpack Cultivator
1. Carefully lift the cultivator out of the box, remove any
packing material and cut any ties holding the handlebar
pieces to the cultivator assembly.
2. Find parts packet. Parts packet contains:
• 4 - T-Handle Nuts (4640)
• 4 - Curved Washers (4641)
• 4 - Saddle Bolts (4642)
Assembly
1. Stand the cultivator assembly upright with tines and wheels
on a level surface. Wheels should be set in the lowest
position. DO NOT place the cultivator on a high surface
where it can fall and cause property damage or personal
injury.
2. Using two T-handle nuts, two saddle bolts, and two curved
washers, attach the middle handlebar to the lower handlebar
that is already connected to the cultivator assembly. The
middle handlebar can be installed in one of two positions,
one high and one low. DO NOT overtighten the T-handle
nuts. SEE FIGURE 1
3. Attach the upper right and left handlebars to the middle
handlebar using the two remaining T-handle nuts, saddle
bolts, and curved washers. DO NOT overtighten the
T-handle nuts. SEE FIGURE 1
4. The drag stake is shipped with point facing upwards.
Before using, remove lock pin and turn the drag stake
around so the point is directed in the downward position
facing towards the tines. Re-insert lock pin.
SEE FIGURE 2
THIS INSTRUCTION BOOK CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
4641
Curved Washers
Qty 4
T-HANDLE NUT
MIDDLE
HANDLEBAR
4642
Saddle Bolts
Qty 4
FIGURE 1
(POINT DOWN FOR OPERATION)
FIGURE 2
UPPER RIGHT
HANDLEBAR
DRAG STAKE
Operator's Manual
MC43 2-Cycle Cultivator
CURVED
WASHER
UPPER LEFT
HANDLEBAR
SADDLE
BOLT
LOW POSITION
MOUNT HOLES
HIGH POSITION
MOUNT HOLES
LOWER
HANDLEBAR
LOCK PIN
9