15073 Border-Edger Kit Installation (Optional Accessory) - EarthQuake MC43 Manuel De L'utilisateur

15073 BORDER-EDGER KIT INSTALLATION (OPTIONAL ACCESSORY)

The Border-Edger Kit is a useful tool for making clean cuts in
the lawn along the borders of gardens, flower beds, walkways,
and driveways for a well manicured look. To install the Border-
Edger Kit, do the following:
INSTALLATION
1. Make sure the cultivator is not running by turning the ON/OFF
switch to the OFF position.
2. Remove the hairpins from both sides of the tine shaft.
3. Remove the tilling tines from the shaft.
4. Remove the drag stake and lock pin from the unit.
5. Store the tines and save the (2) hairpins; they will be used on
the Border-Edger Kit.
6. Slide the border-edger tine onto either side of the tine shaft.
Make sure that the hub collar of the border-edger tine faces
outward, away from the transmission of the cultivator.
SEE FIGURE 10
7. Take the (2) hairpins saved in Step 4 and insert them through
the inner and outer holes in the tine shaft on each side of the
border-edger tine to secure the tine blade in place on the shaft.
SEE FIGURE 10
8. Slide the border-edger wheel onto the opposite side of the tine
shaft as far as it will go.
9. Insert the remaining (1) hairpin, that came with the kit, through
the inner hole to secure the wheel. SEE FIGURE 10
10. Set the cultivator wheels to the HIGHEST (top) position. SEE
FIGURE 5 (PAGE 12)
PARTS BREAKDOWN
ITEM PART DESCRIPTION
NO. NO.
1 15009 BORDER-EDGER TINE
2 46131 BORDER-EDGER WHEEL
3 46134 HAIRPIN
CAUTION
BE AWARE THAT
UNEXPECTEDLY BOUNCE UPWARD, OR JUMP
FORWARD IF THE TINE STRIKES CONCRETE,
PAVEMENT, OR OTHER HARD SURFACES OR
HARD OBSTACLES BURIED UNDER GROUND.
THIS INSTRUCTION BOOK CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
22
THE CULTIVATOR
BORDER-EDGER
WHEEL
HAIR PIN
FIGURE 10
QTY.
1
1
1
COULD
Operator's Manual
MC43 2-Cycle Cultivator
DRAG
STAKE
REMOVED
BORDER-EDGER
TINE
TINE
SHAFT
HUB COLLAR