EarthQuake MC43 Manuel De L'utilisateur page 12

WARNING
DO NOT ATTEMPT TO START ENGINE IN THE
FOLLOWING WAYS:
• DO NOT USE STARTING FLUID
• DO NOT SPRAY FLAMMABLE LIQUIDS OR
VAPORS INTO AIR CLEANER, CARBURE-
TOR, OR SPARK PLUG CHAMBER.
• DO NOT REMOVE
ATTEMPT TO START ENGINE. FLAMMABLE
FUEL CAN SPRAY OUT AND IGNITE FROM
A SPARK FROM SPARK PLUG.
THROTTLE
CONTROL LEVER
ON/OFF
SWITCH
CHOKE
FIGURE 4
Adjusting Wheels and Drag Stake
The wheels on the cultivator can be adjusted to one of three
positions. The LOW wheel position is used for transporting the
cultivator across a smooth level surface while the engine is not
running. The MIDDLE and HIGH wheel positions are used
when tilling in soil and help stabilize the unit when tilling at
different depths. SEE FIGURE 5
To Adjust Wheels Up Or Down do as follows:
SEE FIGURES 5 & 6:
1. Pull the locking metal sleeve against the spring, away from
the vertical guide until it releases from one of the three
notched positions in the vertical guide.
2. Slide the wheel set up or down to the desired position, and
release the locking metal sleeve until it locks into desired
notch in the vertical guide.
THIS INSTRUCTION BOOK CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
12
SPARK PLUG AND
RUN
PRIMER
BULB
To Adjust the Drag Stake do as follows: SEE FIGURE 7
The drag stake is used to help regulate tilling depth and control
the cultivator from leaping forward during operation. Resistance
to forward motion is greatest when the drag stake is set in its
lowest position allowing for deeper cultivation.
1. Pull the lock pin out of the drag stake mount hole.
2. Position drag stake so the pointed tip is directed downward.
3. Insert lock pin into the hole that achieves desired depth.
HIGH
POSITION
MIDDLE
POSITION
LOW
POSITION
FIGURE 5
EXPANDED
SPRING
LOCKING METAL
SLEEVE
(LOCKED POSITION)
FIGURE 6
DRAG STAKE
FIGURE 7
Operator's Manual
MC43 2-Cycle Cultivator
COMPRESSED
SPRING
LOCKING METAL
SLEEVE
(UNLOCKED POSITION)
LOCK PIN