Installation; Positioning And Connection - Ariston BDR 190 NA Notice D'emploi Et D'installation

Installation

! Before placing your new appliance into operation
EN
please read these operating instructions carefully. They
contain important information for safe use, for
installation and for care of the appliance.
! Please keep these operating instructions for future
reference. Pass them on to new owners of the
appliance.

Positioning and connection

Positioning
1. Place the appliance in a well-ventilated humidity-free
room.
2. Do not obstruct the rear fan grills. The compressor and
condenser give off heat and require good ventilation to
operate correctly and save energy.
3. Ensure the appliance is away from any sources of heat
(direct sunlight, electric stove, etc.).
4.
The product was designed exclusively for “built in”
installation and must not be directly exposed to
atmospheric agents.
Levelling
1. Install the appliance on a level and rigid floor.
2. If the floor is not perfectly horizontal, adjust the
refrigerator by tightening or loosening the front or rear
feet.
2
Electrical connections
After the appliance has been transported, carefully place it
vertically and wait at least 3 hours before connecting it to
the electricity mains. Before inserting the plug into the
electrical socket ensure the following:
• The electrical outlet is grounded and compliant with all
electrical codes.
• The outlet can withstand the maximum power of the
appliance, which is indicated on the data plate located
on the right side of the horizontal surface in the top
compartment, under the thermostat (e.g. 150 W).
• The voltage is within the range of values indicated on
the data plate located on the right side of the horizontal
surface in the top compartment, under the thermostat
(e.g. 110V).
• The outlet is compatible with the plug of the appliance.
If the outlet is incompatible with the plug, ask an
authorised technician to replace it (see Assistance).
Do not use extension cords or multiple sockets.
! Once the appliance has been installed, the power supply
cable and the electrical outlet must be easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by
authorised technicians only (see Assistance).
! The manufacturer declines any liability should
these safety measures not be observed.
www.aristonappliances.us