Wolf Garten UV 34 E Mode D'emploi page 13

Never use the aeriator when protective devices or housing
parts are damaged or missing.
Before lifting or removing the aeriator switch off motor an wait
until the operating tools have come to a complete standstill.
Before removing the grassbox or adjusting of the operating
height switch off motor and wait for the complete standstill of
the operating tools.
Replace worn or damaged blades as a complete set. Observe
installation instructions. For safety reasons always use origi-
nal spare parts.
Maintenance and cleaning procedures on the aeriator as well
as removing the protective devices may only be carried out
when the engine is switched off.
Never store the aeriator in damp surroundings or near open fl
ame.
Should have run over an object with the aeriator it should be
examined by a specialist (see list of repair shops) for safety re-
asons.
If the connection cable is damaged during use it must be dis-
connected immediately. Do not touch the cable until it is dis-
connected.
Switch off the lawnmower, pull the mains plug and wait for the
lawnmower to stop running if, for example:
–
leaving the lawnmower
–
unblocking a blade
–
intending to check, clean or work on the lawnmower
Assembly
Fixing the grab handle
1
Caution!
When collapsing and unfolding the grab handle, the cable
could be damaged.
Take care that you do not kink the electrical cable and
the Bowden cable.
See illustrations for assembly.
Operation
Operating times
Please check noise abatement regulations prevailing in your
country.
Feed cable through the strain relief
Please feed cable through the strain relief.
G
A B C D E F G H
J
–
you have encountered a foreign object, in which case you
should check the lawnmower for damage and carry out any
necessary repairs.
–
the lawnmower is vibrating heavily (switch off immediately
and ascertain the cause).
–
you wish to change the settings or carry out cleaning work.
–
you wish to check whether the connection cables have be-
come tangled or damaged.
–
If the connection cable is damaged during use, it must be
immediately disconnected from the mains power supply.
Do not touch the cable before it has been disconnected
from the mains power supply.
Maintenance
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
Pull out the power plug.
Do not touch running blades.
Disposal
Do not dispose of electrical equipment in domestic
waste. Recycle equipment, accessories and pa-
ckaging in an environment-friendly manner.
Connecting to the mains (230 Volts, A.C., 50 Hz)
The mower operates from any normal household mains supp-
ly, provided with a 16 Amps. fuse.
3
Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
Retrofit kits are available for old installations. Consult an elec-
trician.
13