Sending Data To The Pa Amplifier; Programming Mode - Alcad 905-ZA Série Manuel D'installation Et Programmation

38 - ENG
Processor:
DATA
Mode:
Channel
B/G CCIR
Frequency
Bandwidth
Offset
Adjust levels
Tabla
channels
SCREEN
Data error
Reading error An error occurred during the READ function.
6.

SENDING DATA TO THE PA AMPLIFIER

6.1

Programming mode

To start programming the equipment, select Programming on/off in
the programmer and press T. Then wait until the PRG indicator (12) stops
blinking and the indicator that the equipment is waiting to receive data (13)
becomes active before beginning to program each module.
Installation and programming manual
VALUE
Analogue/Digital
C5..12 (ZA-331) Values according to
C21..69 (ZA-431) CHANNELS TABLE.
175,25..231,25 MHz Frequency, VHF (Analogue).
177,50..234,00 MHz Frequency, VHF (Digital).
471,25..855,25 MHz Frequency UHF (Analogue).
473,50..858,50 MHz Frequency UHF (Digital).
8 MHz/7 MHz
-3/6,-2/6,-1/6, 0 Adjustment of the Input/output
+1/6,+2/6,+3/6 offset for digital channels.
-3,-2,-1,-0.5,
+0.5,+1,+2,+3 dB procesador.
B/G CCIR
I UK SM8
D/K OIRT
L FRANCE
Frecuencia
Tab. 7 - Range of values for processor
DESCRIPTION
The data selected does not belong to the range of
values indicated in table 7.
Tab. 8 - Processor warnings
DESCRITION
Analogue or digital channel.
Adjustment of the processor channel
bandwidth to 7 or 8 MHz.
Pasos de ajuste manual del nivel del
Channels for different standards.
Programming by channel or by
frequency.