Alcad 905-ZA Série Manuel D'installation Et Programmation page 32

6- Power supply / control cable
7- Technical datasheet
2.2 Description of the amplifier
8- Connection of mass
9- DAB input F-connector
10- FM input F-connector
11-Infrared transmitter
12- Indicator that the amplifier and the programmer or the modules are
communicating.
13- Indicator that the equipment is waiting to receive data
14- Level control of the FM and DAB output signal
15- Level control of the UHF / VHF output signal
16- Power supply / control connector
17- Infrared receiver
18- F-connector for input from the filters
19- F-connector for signal output
45- F-connectors
20- Technical datasheet
2.3 Description of the double filter
22- Connection of mass
23- F-connector for signal input from the previous module or from the antenna
24- F-connector for signal output towards the next filter
25- Indicator of level of the input channels
26- Programming indicator mode
27- Indicator that module is powered and recognised by the PA
28- Power supply / control connector
29- Pushbutton – programming mode of the modules
30- Boxes in which to note the frequencies / channels
31- F-connector for RF signal input from the previous module
32- F-connector for RF signal output to the next module or the broadband
amplifier
33- Upper and lower connection bridge (41.5 mm)
34- F-loads of 75 Ω
35- Technical datasheet
2.4 Description of the processor
33- Connection of mass
34- F-connector for signal input from the previous module or from the antenna
35- F-connector for signal output towards the next module
36- Indicator of level of the input channels
37- Programming indicator mode
38- Indicator that module is powered and recognised by the PA
39- Power supply / control connector
40- Pushbutton – programming mode of the modules
SERIE 905-ZA ENG - 31