Sending Data To The Tp Transmodulator; Programming Mode; Data Transmission - Alcad 912-TP Série Manuel D'installation Et Programmation

5.

SENDING DATA TO THE TP TRANSMODULATOR

5.1

Programming Mode

For a transmodulator to be programmed, the 'Program' switch (26) must be
switched ON; as this is done, the 'Programming' indicator turns on. While
the indicator is lit, the transmodulator is ready to receive data from the PS
programmer.
On the screen of the level meter will come out the OSD (On Screen Display)
menu of the transmodulator.
Once the transmodulator has been programmed, the Programming Mode
has to be disabled by switching OFF the 'Program' switch. The
'Programming' indicator turns off. The programming indicator will turn off,
the screen of the level meter will come black and after a few seconds the
picture of the selected TV program will be on screen.
5.2

Data Transmission

Select the desired function on the PS programmer screen and adjust the right
value of that function.
To transmit, press the T key. The programming led will blink to indicate that
the receiver has received the data. Besides, the data transmitted will be
stored in the PS programmer.
5.3 OSD Language, output channel and output frequency
selection
Select the language on the PS programmer and in the OSD menu, pressing
F LANG. and F for confirming.
When the
Output channel B/G CCIR C
programmer screen, you could select standard channels meanwhile when
Serie 912-TP
Fig. 9 - Program mode
ENG - 33
is displayed in the PS