Finishing The Installation; Testing The Signal Strength; Carrying Out A Signal Strength Test - Abus FUMO50030 Instructions D'installation

7.5. Finishing the installation

If no wireless location check has been made, then it is im-
portant that the strength of the incoming signal is checked now
(see "Testing the signal strength").
When the signal strength is satisfactory:
3. Reattach the piezo signaller cable to the PCB.
4. Attach the front part of the housing to the rear wall and
fasten it with the screw (carry out the steps in figure 1
in reverse order).

8. Testing the signal strength

The info module can display the signal strength of signals re-
ceived from the alarm centre.
Important:
Make sure that the alarm centre is taught to the info
module.
Ensure that a jumper is inserted for selecting the parti-
tion.

8.1. Carrying out a signal strength test

As soon as the info module has received a signal from the wire-
less alarm centre, press the button for displaying the signal
strength on the info module (use a long, sharp tool that fits
through the hole on the bottom of the housing).
30