Acoustic Signal Tones - Abus FUMO50030 Instructions D'installation

LED ready (red)
Lights up when at least one zone on the set partition is opened or
the centre is in installer mode.
(The menu point "INSTALLER MENU
 
Other Devices Info
Rdy-to-Set LED" on the wireless alarm cen-

Module/Int Siren
tre must be set to "Activated".)
LED delay time (yellow)
Lights up when the input or output delay runs.
LED alarm (red)
Lights up when an alarm is triggered. The piezo signaller also
emits a sound.
A small hole at the bottom-right of the housing provides access to
an internal switch that is used for monitoring the signal strength.

6. Acoustic signal tones

The info module can generate a whole series of acoustic signal
tones. These are similar to the signal tones of the wireless
alarm centre. At the same time, the internal piezo signaller of
24