Compatible Equipment; Installation; Step 1: Select Installation Location For The Sounder; Step 2: Open The Sounder's Cover - Abus Secvest FUSG50101 Instructions D'installation Et D'utilisation

Installation

Compatible equipment

• FUAA50xxx Secvest Alarm Panels all software versions
• FUMO50010 wireless repeater
• FUMO50020 wireless universal module (repeater function)
• FUAA10011 Secvest-IP
• FU8000 Secvest 2Way
• FU5000 Secvest
Installation

Step 1: Select installation location for the sounder

Select an installation location which:
• is inaccessible to intruders and vandals
• is located well out of reach (>3 m)
• is clearly visible, so that it acts as a strong deterrent
• is within the wireless range of the alarm panel (max. 500 m outdoors).
Note
The wireless signal strength should be tested using the test box at the installation
location for the sounder and the alarm panel prior to installation.
The sounder must not be installed in the following locations:
• at a distance of less than 1 m from large metal structures such as metal doors or frames,
water tanks, refrigerators or cars
• at a distance of less than 1 m from household electrical systems, distributors or metal pipes
• inside metal housings
• close to high-voltage devices or electronic devices such as computers, photocopiers or
other wireless devices

Step 2: Open the sounder's cover

• Open the two covers for the two lid-fixing screws (see Fig. 1).
• Remove the fixing screws and open the cover.
40 | EN