Balugani BAV5 Mode D'emploi page 14

EN
PERIODIC MAINTENANCE AND CONTROLS
At least twice a year you need to clean the brine vat to remove sediments and foams which might form periodi-
cally because of salt deposits.
The resins in the tank have an average life of 5 years, after this period they must be replaced by qualifies
personnel.
To check the condition of the resins, test the hardness of the water immediately after the end of a regeneration.
Should the water be "hard", it might be that the capacity of the resins to perform their softening function is exhausted,
and that they have to be replaced.
Since the regeneration of the resins takes place by means of a hydro-saline solution formed through salt dissol-
ving in water, it is necessary to frequently check the level of salt in the vat and to fill it if there is not enough.
For an ideal functioning of the softener we recommend salt for water softeners in TABS. Products other
than salt for softeners could damage it permanently and these damages will not be covered by the guarantee.
If there is a filter upline of the device, this must be regularly cleaned 3-4 times a year and, if necessary, the filter
cartridge must be replaced with a similar one.
SELECTION OF THE LANGUAGE ON THE DISPLAY
The control valve of the softener has a multilingual display.
To select a different language, follow these instructions:
Display
Menu/confirm
Back
1. The control valve must not be connected to the power supply (switched off).
2. Connect the control valve to the power supply
3. Press immediately and at the same time keys
4. After about 5 seconds the list of the available languages will appear
5. Releaser the two keys
6. Using the arrows keys (up and down) select the desired language and press
Now the display will use the selected language.
This handbook is the property of Balugani s.r.l. - Reproduction without prior permission of the owner is forbidden
14
Up
Down
to confirm.