VESTEL EVC02-AC22 Serie Manuel D'utilisation page 6

4. Charging device is now in configuration mode.
Now follow the below steps for registering master
card:
1. Tap your card to the RFID reader on the Charging
Device (first card tapped to the RFID reader is
defined as master card). Please note that you need
to tap your card latest in 20 seconds after entering
configuration mode.
2. Led light color turns to steady blue.
Now configuration mode ended and your master
card is registered successfully. Your charging device
is ready for charging."
Please note that;
* Previously stored master card and user card list ,
if any exists, are deleted from charging station while
entering the configuration mode .
* If any power interruption occurs during this mode,
charging station starts as autostart product.
* If master card had not been registered during
20 seconds then configuration mode expires and
charging station behaves as autostart product.
* If master card is successfully registered then please
follow instructions in "section b" to register RFID user
card which is used during charging process.
b.Registering RFID User Cards
Master
You need your RFID Master card (see section a)
to register new User cards to the charging station.
Please follow the steps below for registering a User
card:
1. Tap your RFID master card to the charging station.
2. Following the one time beep sound tap the user
card that you want to register.
3. You will hear short beep sound two times in a row,
the button will blink blue for two seconds and the
registration process will be completed.
Apply this procedure for all user cards that you want
to register. Your charging station have a memory for
registering maximum 20 user cards.
c. Removing Registered User Cards
Please follow the steps below for removing the
registered RFID user cards from the charging station:
1. Tap your RFID master card to the charging station.
2. Following the one time beep sound tap the user
card that you want to remove.
3. You will hear two times short beep sound, the
button will blink red for two seconds and the process
is completed.
Apply this procedure for all the user cards that you
want to remove from the registered list.
d.Charging
1. Connect charging cable to your EV and charging
station successively.
2. Charging station waits for the RFID card
authorization, please tap any of the user cards over
the RFID reader symbol on the charging station.
3. You will hear one time beep sound if the user card
is in the authorized card list then charging session
will start immediately.
Please Note: If the tapped user card is not in the
authorized card list then you will hear 3 times beep
sound and charging station will not allow charging.
User
English - 4 -
User