Troubleshooting - VESTEL EVC02-AC22 Serie Manuel D'utilisation

TROUBLESHOOTING

PROBLEM
The product button LED is not lit
when it is energized.
The charging station does not
start charging vehicle although
the button LED is blue.
The product does not lock the
cable in charging state.
The button LED is blinking red.
The button LED is steady red.
POSSIBLE REASONS
There might be power outage or
the circuit breaker can be tripped.
The charging cable might not
be connected properly to the
charging station and vehicle. The
vehicle is not in
charging state or its battery is
full.
The charging cable might not
be connected properly to the
charging station and vehicle.
Your vehicle needs ventilation
during charging because of the
drivetrain battery type. This
vehicle charger unit is intended
only for charging electric vehicles
not requiring ventilation during
charging.
The AC supply voltage may not
be within the range specified
in user manual, there may be
a failure on electric vehicle or
charging station.
English - 15 -
SUGGESTED
SOLUTIONS
Check the circuit breaker is
not tripped and ensure that the
charger is supplied with power.
Be sure that charging cable is
connected properly to both sides.
Please check your vehicle if it is
in charging mode or not.
Be sure that cable is connected
properly. If the problem still
continues, please consult the
service.
You need to use appropriate
charging station in connection
with an appropriate ventilation
unit for charging your vehicle.
Please be sure that the voltage
is within the specified range.
Please remove the charging
cable firstly from electric vehicle
then from charging station. To
clear the error state, press the
button for at least five seconds.
If the button is still steady red,
please contact authorized
service.
If the same problem occurs again
during charging, the problem
may be in the electric vehicle
side. Please contact your local
car dealer.