Important - Bio Green THERMO 2 Mode D'emploi

1. Scope of supplyl
Digital-Thermostat Thermo 2
1 pcs.
2. Technical data
1. Scope of supplyl
Type of unit:
1 Digital-Thermostat Thermo 2
Power supply:
Incl. suspension device
Max. breaking capacity:
Max. switching current:
2. Technical data
Control range:
Type of unit: Switch-off temperature
Power supply:
Switch-on temperature
Max. breaking capacity:
Distinction rate:
Max. switching current:
Measuring temperature range:
Control range:
Switching accuracy:
Distinction rate:
Measuring temperature range: -50 to 99 ° C
Input:
Switching accuracy:
Protection class:
Input:
Protective system:
Protection class:
Sensor length:
Protective system:
Sensor length:
Power cable:

IMPORTANT:

Read carefully and follow these instructions as well as the general advice on safety and risks before
installation. Keep this leaflet in a safe place for future reference. If you have any doubt about the
safety of the unit seek the advice of an expert. If the unit is used in a greenhouse make sure that the
electrical connections are carried out by qualified personnel.
3. General
After unpacking and before switching on, make sure that the unit and all its accessories are perfectly
in order. If there has been any damage in transit, consult your dealer or the manufacturer immediately.
Keep the packaging materials (polythene bag, polystyrene, nails etc.) out of reach of children because
they represent a potential source of danger. This also applies to small parts supplied, which can be
swallowed.
This electronic thermostat can be used for a wide variety of temperature control applications, for
example for heating and cooling greenhouses and winter gardens, or for monitoring water
temperatures in aquariums, the air temperature in terrariums or the soil temperature in seed beds. It is
simple to operate and can be connected to any type of heating cable, heating mat or other heating or
cooling devices, provided that the maximum heating power of 3000 W is not exceeded.
This thermostat is only licensed for connection to 230 V / 50-60 Hz a.c. voltage. The unit must be
protected from high degrees of contamination and moisture.
If it is used for any application other than that described above it may be damaged and risks such as
short-circuiting, fire, electric shock etc. may ensue. The safety and installation instructions must be
strictly adhered to.
Digital-Thermostat Thermo 2
Incl. suspension device
Thermo 2
230 V / 50-60 Hz
3000 W
16A
0 – 40 °C
Thermo 2 = Adjusted temperature
230 V / 50-60 Hz
= 2° C lower the switch-off temperature
3000 W
± 1 °C
16 A
-50 to 99 °C
0 – 40 ° C
± 1 °C
± 1 ° C
< 1,5 W
± 1 ° C
II
< 1,5 W
IP X4
II
approx. 280 cm
IP X4
approx. 1.0 m
approx. 100 cm
9
Digital-Thermostat THERMO 2
EN
EN