Important - Bio Green THERMO 2 Notice De Montage Et D'utilisation

1. Scope of supply
1 Digital-Thermostat Thermo 2, Incl. suspension device
2. Technical data
Type of unit:
Power supply:
Max. breaking capacity:
Output capacity:
Control range:
Distinction rate:
Measuring temperature range:
Switching accuracy:
Input:
Protection class:
Protective system:
Sensor length:
Note:
Measuring temperature range: -50 to 108 °F
A0--100 °F A01--101°F A02--102°F A03--103°F A04--104°F
A05--105°F A06--106°F A07--107°F A08--108°F

IMPORTANT:

Read carefully and follow these instructions as well as the general advice
on safety and risks before installation. Keep this leaflet in a safe place for
future reference. If you have any doubt about the safety of the unit seek
the advice of an expert. If the unit is used in a greenhouse make sure that
the electrical connections are carried out by qualified personnel.
3. General
After unpacking and before switching on, make sure that the unit and all its accessories
are perfectly in order. If there has been any damage in transit, consult your dealer or
the manufacturer immediately. Keep the packaging materials (polythene bag, polys-ty
rene, nails etc.) out of reach of children because they represent a potential source of
danger. This also applies to small parts supplied, which can be swallowed. This electr-o
nic thermostat can be used for a wide variety of temperature control applications, for
example for heating and cooling greenhouses and winter gardens, or for monitoring
water temperatures in aquariums, the air temperature in terrariums or the soil temp-e
rature in seed beds. It is simple to operate and can be connected to any type of heating
cable, heating mat or other heating or cooling devices, provided that the maximum
heating power of 1500 W is not exceeded. This thermostat is only licensed for connecti-
on to 110VAC ±10%, 50/60Hz voltage. The unit must be protected from high degrees of
contamination and moisture. If it is used for any application other than that described
above it may be damaged and risks such as short-circuiting, fire, electric shock etc. may
ensue. The safety and installation in-structions must be strictly adhered to.
Thermo 2
110VAC ±10%, 50/60Hz
1500 W
15A/125VAC
0 – 40 °C / ± 0 – 90 °F
± 1 °C / ± 1 °F
-50 to 108 °F
± 1 °C / ± 2 °F
< 1,5 W
II
IP X4
approx. 40"
3