Bio Green THERMO 2 Notice De Montage Et D'utilisation page 6

6. Operation
When installing, check that the unit or mains cable is not damaged. Also make sure
that the sensor cable has not become sharply kinked as this may impair operation.
Switching on/off
As soon as the unit has been connec-
ted to the supply voltage it can be
switched on by means of the „ON/
OFF" button. To do this the button
must be press for 3 seconds. Imme-
diately after switching on the unit
determines the ambient tempera-
ture of the sensor and indicates it
on the display. To switch off, again
press the „ON/OFF" button for 3 se-
conds.
Heat/Cool mode
It is possible to alternate between
the heat and cool mode by pressing
the button. Keep the
button pressed for 3 seconds to
change mode. On the display „H" ap-
pears for 4 seconds for heating and
„C" for cooling. At the same time you
can detect the mode that has been
set by means of the The red LED
stands for heating and the green
LED for cooling.
Setting the required temperature
Press the p or q button briefly to switch to the setting mode. The already set tem-
perature now flashes in the display. Using the p and q buttons you can change the
temperature in 1 °F steps. (Setting range -50 °F to +99 °F). After you have set a new
temperature, it is saved automatically and the menu closes after 3 seconds. Now the
display again shows the current ambient temperature.
Celsius/Fahrenheit unit selection:
Under normal running status, short press q key or p key and immediately release it, it
enters to temperature setting state, and it blinkingly displays the current set tempera-
ture. At this time, hold and press C / H key for more than 5 seconds , the system enters
Celsius and Fahrenheit setting state , LED blinkingly flashes C and F. Switch between
Celsius and Fahrenheit by pressing q key or p key. When finish setting, it will exit
in 3s if there is no key operation, and return to the normal running state and save the
parameters automatically. If an error occurs during saving parameter, it displays „Er",
and 3 seconds later, it returns to normal display state.
Heat Heat and cool
LED mode on LED
Temperature
selction buttons
Display /
Temp indication
6
Cool
LED
Cool /Heat
mode
On/Off
button