Bio Green THERMO 2 Mode D'emploi page 11

Digital-Thermostat Thermo 2
5. Installation
Make sure that the mains voltage corresponds to the voltage indicated in Chapter 2 (technical data).
The place of installation must be chosen so that the unit can under no circumstances get wet (e.g.
dripping condensation, open roof hatches, etc.) or fall into water.
The thermostat may be operated in a horizontal or vertical
position.
1. Connect the heating or cooling unit to the thermostat. To do
so, insert the plug of the corresponding heating or cooling
unit in the socket on the thermostat.
2. Now connect the connecting cable of the thermostat to a
230V mains socket.
3. Position the end of the sensor cable at the most suitable
point for temperature control.
Room temperature control
The sensor should be installed at half room height and
should be freely suspended. The room temperature can only
be optimally controlled when the sensor is not influenced by
draughts, solar radiation or other heat or cold sources.
Cultivation of plants and seeds
Position the sensor in the soil close to the roots. The sensor
must be entirely surrounded by soil. In large plant pots the
sensor should be located in the middle of the pot.
Water temperature control
For water temperature control (e.g. in an aquarium), the sensor should be positioned in the central
layers of water. Here too the sensor must be completely surrounded by water.
Digital-Thermostat THERMO 2
1
- 11 -
11
2