Uline H-5485 Mode D'emploi page 2

NOTE: Uline recommends raising the hopper
on a forklift for assembly. If a forklift is
not available, tilt dumping hopper on its
side. Make sure hopper is stabilized before
proceeding.
RAISE HOPPER ON FORKLIFT
1. Drive lift truck forward until hopper's fork pockets
contact vertical legs of lift truck forks. (See Figure 1)
Figure 1
2. Wrap the safety chain around the fork carriage and
attach the quick link on the chain. There should be
no slack in the chain. (See Figure 2 and Figure 2a).
Figure 2
3. Raise forks to a comfortable
working height.
4. Unlock the latch and dump the
hopper.
ATTACH HANDLE SOCKET BRACKETS
Attach the socket brackets on either side of the hopper
base. Right socket bracket is offset to the right. Left
socket is offset to the left. (See Figure 3)
Figure 3
PAGE 2 OF 21
ASSEMBLY
1. Insert two 3/8-16 x 1½" bolts through the two bolt
holes in the right socket bracket.
2. Slide the bolts through the
two bolt holes on the right
side of the base frame.
(See Figure 4)
3. Secure each bolt with a
3/8" locknut using a 9/16"
deep well socket wrench,
but DO NOT TIGHTEN.
4. Repeat steps 1-3 to install the left socket bracket.
ATTACH HANDLE
1. Insert the handle legs into the sockets. Maneuver
handle legs into place until they are all the way into
the socket.
2. Tighten the set screws on the back of the socket
brackets against the handle legs using a 9/16"
wrench.
ATTACH CASTERS
Install rigid casters on the front of the hopper and swivel
and swivel with brake casters on the back of the hopper
(See Figure 5).
Figure 5
Rigid
Caster
Figure 2a
Caster
NOTE: Put handle legs into sockets evenly. Do
not put in one at a time.
Swivel
Figure 4
Bolt
Rigid
Caster
Swivel
Caster
with
brake
0621 IH-5485