Power Failures; Shelves - Cavavin V-024WDZFG Manuel D'instruction

If your wine cellar appears to be malfunctioning, unplug it and contact your Cavavin's after sales service. Any intervention
on the cold circuit should be performed by a refrigeration technician who should carry out an inspection of the circuit
sealing system. Similarly, any intervention on the electrical circuit should be performed by a qualified electrician.
Notes: Any intervention performed by a non-authorized technician by Cavavin will lead to the warranty being considered
as null and void.

Power Failures

In the event of a power interruption, all previous temperature settings are automatically preserved, and it will revert to a
pre-set temperature setting.
Most power failures are corrected within a short period of time. An hour or two's loss of power will not affect wine cellar's
temperatures. To avoid sudden change of temperature while the power is off, you should avoid opening the door. For
longer period of power failure, do take action to protect your wine. Irrespective of the cause, if you notice either abnormal
temperature or humidity levels inside your wine cellar, be reassured that only long and frequent exposure to these
abnormal conditions can cause a detrimental effect on your wines.

Shelves

For easy access to the storage content, you must pull the shelves
approximately 1/3 of its depth out of the rail compartment. These wine
cabinets, however, are designed with a notch on each side of the shelf
tracks to prevent bottles from falling. When removing any of these
shelves out of the rail compartment, tilt the shelf as per the diagram and
simply pull out, or push in the shelf until it sits on the support brackets
securely.
To remove the shelves out of the rail pull each shelf approximately 1/3 out. Use a long flat screwdriver to press down
the right plastic notch as shown in Figure [2] and at the same time lift the left plastic notch as shown in Figure [2]. Then
proceed to pull out the shelf slowly.
Fan
To clean the fan of the cellar, remove the kickplate using a screwdriver to loosen the two screws and clean the dust that
can be accumulated. It is very important to do this at least once a year.
39