Connecting To Power - AKG CU400 Mode D'emploi

• Check that the AC mains voltage stated on the included power supply is identi-
cal to the AC mains voltage available where you will use your system. Using the
power supply with a different AC voltage may damage the unit.
• Do not use any power supply other than the AC adapter supplied with the
charger.
• Never connect the CU 400 charger to the PSU 4000 central power supply be-
cause the output voltage of the PSU 4000 is incompatible with the CU 400.
1. Connect the DC cable of the supplied AC adapter to the DC 5 V jack on the charger rear
panel.
2. Connect the AC adapter to a convenient power outlet.
3. The charger is ready to operate. Note that both STATUS LEDs remain dark.
CU 400

3 Connecting to Power

Important!
15