Commissioning / Operation; Maintenance, Repair, Disposal; Technical Data; Power Supply - IFM Electronic efector 300 VS 0200 Notice D'utilisation

C /
OMMISSIONING OPERATION

7. Commissioning / operation

After mounting, wiring and setting check whether the unit operates correctly.
For units with monitoring of the sensor cable: In the case of wire break or short
circuit the relay "wire monitoring" is de-energised and the red LED lights. After
rectification of the fault the control monitor is again ready for operation.
Check whether the external SELV circuits are sufficiently insulated.

8. Maintenance, repair, disposal

In case of correct use no maintenance measures are necessary.
Depending on the switching rate to be expected and the load to be switched,
we recommend testing the relay contacts.
Only the manufacturer is allowed to repair the unit.
After use dispose of the unit in an environmentally friendly way according to
the valid national regulations.

9. Technical data

Power supply

For AC units with transformer power supply:
According to the type label AC voltage at the terminals 15 (L1) and 16 (N),
- frequency range 47 ... 63 Hz,
- voltage tolerance ± 10%.
For this supply the unit is classified in protection class 2 except for the
terminal blocks. The protective low voltage generated within the unit for the
monitor supply and pulse pick-up supply meets the SELV criteria according to
overvoltage category 2 and soiling degree 2.
Power consumption max. 3 VA.
DC units:
24 volt DC ± 10%, at the terminals 15 (+) and 16(-).
An external DC voltage supply must meet the SELV requirements.
For this supply voltage the unit is classified in protection class 3.
Current consumption max. 70mA.
page 14
, M ..., T
AINTENANCE ECHNICAL DATA