Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
160992A3WF 08-18 GWS18V-45C.qxp_GWS 8/28/18 1:07 PM Page 14
QUICK-CLAMPING NUT
Use the quick-clamping nut to secure the
grinding/cutting disc without the need for
additional tools. Only use the quick-clamping
nut for grinding/cutting discs up to a maximum
diameter of 4 1/2".
• The quick-clamping nut may be used
only for grinding or cutting discs.
• Only use quick-clamping nuts that are in
good working order and not damaged.
• When screwing on, make sure that the
printed side of the quick-clamping nut is
not facing the grinding disc.
Press the spindle lock
button to lock the
grinding spindle. To
tighten the quick-
clamping nut, fold up
the bar and turn the
quick-clamping nut
firmly clockwise. Then
fold down the bar to
secure the quick-
clamping nut. It is not
sufficient to tighten the
disc along the edge.
SANDING ACCESSORIES ASSEMBLY
BACKING PAD
safe operating speed is not exceeded by the
nameplate speed of the tool.
operations. Always reinstall wheel guard when
converting back to grinding operations.
pad for sanding accessories.
TO INSTALL BACKING PAD AND
SANDING DISC (Not Included)
Disconnect battery pack from tool.
Attach hand guard (Fig. 1). Set the tool on its
top side (spindle up). Place the rubber
backing pad onto the spindle shaft. Center
the sanding disc on top of the backing pad.
Insert the lock nut through the disc and
thread onto the spindle as far as you can
with your fingers. Press in the spindle lock,
then tighten the backing pad securely with
lock nut wrench (Fig. 6).
TO REMOVE: Reverse procedure.
Before attaching a backing
pad be sure its maximum
Wheel guard may not be
used for most sanding
Do not use the Quick-
Clamping Nut with backing
A properly secured,
undamaged
quick-
clamping nut can be
removed by hand. To
do this, fold up the bar
and turn the quick-
clamping nut firmly
anticlockwise, Fig 8. If
the quick-clamping nut
is
stuck,
do
not
attempt to loosen it
with a tool – always
use a two pin spanner.
with
Operating Speed rated at least equal to the
maximum speed marked on the power
tool. This speed is based on the strength of
the wheel. It is not meant to imply a best or
most efficient operating speed. Do not exceed
the Maximum Safe Operating Speed.
FIG. 6
SPINDLE
WIRE BRUSH
-14-
Only use accessories
Maximum
Safe
BACKING
PAD
SANDING
DISC
LOCK NUT
(OPTIONAL)
Publicité
Table des Matières
