Front Stop Adjustment - Adjustable Trunnion - Blatchford ESK+ 4-Bolt Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19

9 Front Stop Adjustment - Adjustable Trunnion

The instructions in this section are for practitioner use only.
Fitted to the PSPC
1
Fully tighten front stop.
3
Apply a light extension load to the knee and
gradually unscrew the piston rod (lengthening
the cylinder) until the chassis edge is parallel
with the top of the shin.
Front Stop Adjustment - Non-Adjustable Intelligent Prosthesis
(As fitted to older SmartIP models.)
No adjustment is necessary when using these cylinders. They require the front stop to be fully
tightened as shown in Stage 1.
For adjustment of swing control devices see appropriate IFU.
2
4
Note... The stop pads mounted
in the chassis and side plate are
required to support ML loading.
Simultaneous full contact between
the stops and the shin is NOT
required.
Withdraw trunnion clamp screw
and apply LOCTITE 222 to thread,
re-assemble and tighten.
*UNDER NO CIRCUMSTANCES MUST
THE PISTON ROD WITNESS LINE BE
VISIBLE BELOW THE TRUNNION.
11
Loosen trunnion
clamp screw.
Turn piston rod to
reveal thread and
apply Loctite 243.
Reassemble and
screw piston rod
fully home. The
chassis should now
be slightly flexed.
6 A/F -PSPC
938404PK1/1-0121

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Esk4bp30Esk4bppyrSmartip4b30Smartip4bpyrEsk4b30Esk4bpyr

Table des Matières