Putting Into Operation - Herbert Kreitel HD 150 Manuel

Putting into Operation

Switching On/Off
Switching on:
Press the "on/off" button 6 or the measurement button 7 completely
down.
Switching off:
Press the "on/off" button 6.
After approx. 5 min without performing a measurement, the unit switches
off automatically to save the batteries.
With the automatic switch-off, the current display and the settings of the
unit are also stored in addition to the already stored measured values.
When switched on again, the unit is in the same function and shows the
same display as before the automatic switch-off.
Changing the Measuring Unit
After switching on the measuring instrument, the measured values are
shown in the unit that was selected the last time the measuring instrument
was used.
For areas or volume entries, only units of m or ft are possible.
Measuring Procedure
The instrument has several measuring functions that can be selected by
pressing the respective function button (see Measurement Functions
Section). After switching on, the instrument is in the "Length Measuring"
function.
To change the measuring function, press the button for the desired func-
tion. After selecting the measuring function, all further steps take place by
pressing the measure button 7.
Place the rear end of the unit (end piece) at the desired measuring position
(e.g. on a wall). The rear end of the unit is the reference point for the mea-
surement.
– To switch on the laser beam, lightly press the measurement button 7
in the middle or press at the side.
– Aim at the target.
Do not point the laser beam at persons or animals.
I
– To measure, press the measure button 7 completely down.
The measured value appears after 0.5 to 4 s. The end of the measure-
ment is indicated by an acoustical signal. The duration of the measure-
ment is dependent on the distance, light conditions and reflection charac-
teristics of the measured surface. After completion of the measuring
procedure, the laser switches off automatically.
1 609 929 E86 • (02.12) T
With repeated pressing of the "m/ft" button
10, switching between the units of measure
shown here can be made at any time, also for
already calculated values.
Exception: If the continuous laser beam is
switched on (see Continuous Pointer Mode),
the measuring unit cannot be changed.
www.kreitel-vermessungsgeraete.de
American English–5