Dacor EF36BNNF Manuel D'utilisation Et D'entretien page 16

The ice maker is not producing ice or not
enough ice
Refrigerator connected to a water supply and the supply
„
shutoff valve turned on? Connect refrigerator to water supply
and turn water shutoff valve fully open.
Kink in the water source line?
„
water flow. Straighten the water source line.
Ice maker turned on? Make sure wire shutoff arm or switch
„
(depending on model) is in the on position.
New installation? Wait 24 hours after ice maker installation for
„
ice production to begin. Wait 72 hours for full ice production.
Freezer door closed completely?
„
compartment door. If the freezer compartment door will not
close all the way, see The doors will not close completely.
Large amount of ice recently removed?
„
ice maker to produce more ice.
Ice cube jammed in the ice maker ejector arm?
„
from the ejector arm with a plastic utensil.
Water filter installed on the refrigerator?
„
operate ice maker. If ice volume improves, then the filter may
be clogged or incorrectly installed. Replace filter or reinstall it
correctly.
Reverse osmosis water filtration system connected to
„
your cold water supply? This can decrease water pressure.
See the installation instructions.
The ice cubes are hollow or small
NOTE: This is an indication of low water pressure.
Water shutoff valve not fully open?
„
valve fully open.
Kink in the water source line?
„
water flow. Straighten the water source line.
Water filter installed on the refrigerator?
„
operate ice maker. If ice quality improves, then the filter may
be clogged or incorrectly installed. Replace filter or reinstall it
correctly.
Reverse osmosis water filtration system connected to
„
your cold water supply? This can decrease water pressure.
See installation instructions.
Questions remain regarding water pressure?
„
licensed, qualified plumber.
Off-taste, odor or gray color in the ice
New plumbing connections?
„
cause discolored or off-flavored ice.
Ice stored too long? Discard ice. Wash ice bin. Allow 24
„
hours for ice maker to make new ice.
Odor transfer from food?
„
packaging to store food.
Are there minerals (such as sulfur) in the water?
„
filter may need to be installed to remove the minerals.
Water filter installed on the refrigerator?
„
discoloration in ice indicates that the water filtration system
needs additional flushing. Flush the water system before using
a new water filter. Replace water filter when indicated. See
page 3.
Before You Call for Service
A kink in the line can reduce
Firmly close the freezer
Allow 24 hours for
Remove ice
Remove filter and
Turn the water shut off
A kink in the line can reduce
Remove filter and
Call a
New plumbing connections can
Use airtight, moisture proof
A water
Gray or dark
The water dispenser will not operate properly
Refrigerator connected to a water supply and the supply
„
shutoff valve turned on? Connect refrigerator to water supply
and turn water shutoff valve fully open.
Kink in the water source line?
„
line.
New installation? Flush and fill the water system. See the
„
installation instructions.
Is the water pressure at least 35 psi (241 kPa)?
„
pressure to the home determines the flow from the dispenser.
See the installation instructions.
Water filter installed on the refrigerator?
„
and operate dispenser. If water flow increases, the filter may
be clogged or incorrectly installed. Replace filter or reinstall it
correctly.
Refrigerator door closed completely?
„
If it does not close completely, see The doors will not close
completely.
Recently removed the doors?
„
dispenser wire/tube assembly has been properly reconnected.
See the installation instructions.
Reverse osmosis water filtration system connected to
„
your cold water supply? This can decrease water pressure.
See the installation instructions.
Water is leaking from the dispenser system
NOTE: One or two drops of water after dispensing is normal.
Glass not being held under the dispenser long enough?
„
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
New installation? Flush the water system. See the installation
„
instructions.
Recently changed water filter?
„
the installation instructions.
Water on the floor near the base grille?
„
water dispenser tube connections are fully tightened. See the
installation instructions.
Water from the dispenser is warm
NOTE: Water from the dispenser is only chilled to 50°F (10°C).
New installation? Allow 24 hours after installation for the
„
water supply to cool completely.
Recently dispensed large amount of water?
„
for water supply to cool completely.
Water not been recently dispensed?
„
may not be cool. Discard the first glass of water.
Refrigerator connected to a cold water pipe?
„
the refrigerator is connected to a cold water pipe. See the
installation instructions.
14
Straighten the water source
The water
Remove filter
Close the door firmly.
Make sure the water
Flush the water system. See
Make sure the
Allow 24 hours
The first glass of water
Make sure