Setting Dome Camera Address (Id) - Eneo HDD-2030PTZ1080 Mode D'emploi

Termination ON
Cable for communication
Cable for communication
Termination ON
Figure 8 - Termination Diagram

Setting Dome Camera Address (ID)

To prevent damage, each dome camera must have a unique address (ID).
The factory default setting is 1.
Refer to 'Dome Communication' section for detailed information.
Cable for communication
Dome 1 port Dome 2 port
Termination ON
1.2km
Termination ON
Cable for communication
Repeater /
Splitter
1.2km
Input
Termination ON
Output
Termination ON
Termination ON
EN
19