Mobile Home Installation - Ashley AP5660L Mode D'emploi

Masquer les pouces

Table des Matières

OUTSIDE AIR SUPPLY

MOBILE HOME)

Depending on your location and home construction,

outside air may be necessary for optimal performance.

Metal pipe (solid or flexible) must be used for the outside

air installation. PVC pipe is NOT approved and should

NEVER be used.

A wind shield over the termination of the outside air

pipe or a 90-degree elbow or bend away from the

prevailing winds MUST be used when an outside air pipe

is installed through the side of a building. The outside air

termination MUST be at least 1ft (0.305m) away from the

exhaust system termination.

The outside air pipe on your heater is 2" (50.8mm) OD.

The outside air connecting pipe must be at least 2"

(50.8mm) ID. The outside air connection used MUST NOT

restrict the amount of air available to your heater. The

outside air connecting pipe must be as short and free

of bends as possible, and it must fit over, not inside, the

outside air connection to the heater.

NOTE: Dimensions from the floor to your stoves

inlet/exhaust pipes are approximate and may vary

depending on your installation.

Mobile home installation should be done in accordance

with the Manufactured Home and Safety Standard (HUD),

CFR 3280, Part 24. Canadian installations require that the

heater must be connected to a 3 or 4 inch, factory-built

chimney conforming to CAN/ULC-S629. See the installation

illustrations in this manual for minimum height above the roof.

The chimney installation must allow for removal in case of

mobile home transportation, especially outside connections.

You may contact your local building authority or person

having jurisdiction on height restrictions.In order for this unit

to be installed in a mobile home the following criteria must

be met:

• The unit must be secured to the floor using lag bolts in the

holes provided in the pedestal base.

• Ensure that the unit is permanently electrically grounded

to the chassis of your home with 18 gauge copper wire.

• All exhaust systems must have a spark arrestor.

IT IS MANDATORY TO TAKE THE COMBUSTION AIR FROM

THE OUTSIDE WHEN INSTALLING THIS UNIT IN AIR TIGHT OR

MANUFACTURED/MOBILE HOMES.

CAUTION: The structural integrity of the manufactured home

floor, wall, and ceiling/roof must be maintained. Make sure

to maintain an effective vapor barrier by sealing with silicone

where the chimney or other components penetrate to the exterior of the structure. Refer to and follow the

chimney manufacturer's installation instructions.

WARNING: Do not install in sleeping room.

(OPTIONAL, UNLESS INSTALLING IN A