Ash Removal - Ashley AP5660L Mode D'emploi

ASH REMOVAL

1. Allow Heater to cool to room temperature
2. Lift the ash pan door up and pull out
3. Follow directions for free-standing unit above on this page.
SMOKE AND CO MONITORS
Burning wood naturally produces smoke and carbon monoxide(CO) emissions. CO is a poisonous gas when
exposed to elevated concentrations for extended periods of time. While the modern combustion systems in
heaters drastically reduce the amount of CO emitted out the chimney, exposure to the gases in closed or confined
areas can be dangerous. Make sure your stove gaskets and chimney joints are in good working order and sealing
properly to ensure unintended exposure. It is recommended that you use both smoke and CO monitors in areas
having the potential to generate CO.
Your decorative logs should come in place, however if this is not the case the following steps depicts the correct
location.
Locate the Burn Pot.
Burn Pot
18
Decorative Log Placement
STEP 1
Above are the decorative logs in there correct location.
STEP 2
Place log into correct position.