Removing The Battery Pack; Installing The Battery Pack - GreenWorks ELITE CS-80-XR-T Manuel Du Propriétaire

OPERATION INSTRUCTION
BATTERY PACK (See Figure 6)
I M P O R T A N T
The battery pack is not charged when it is purchased. Before using the pole saw for the first
time, place the battery pack in the battery charger and charge it fully. Be sure to read all safety
precautions, and follow the instructions in the section entitled Charging Procedure. With regular
use, the battery will require shorter charging times. When storing the pole saw for a prolonged
period of time, remove the battery. When the pole saw is going to be used again, charge the battery
pack for at least a full charging period. This product has no memory effect.

REMOVING THE BATTERY PACK

• Press the latch button on the battery pack down and hold.
• Grasp the pole saw firmly, and pull the battery pack out of the handle.
NOTE: The battery pack fits into the handle snugly in order to prevent accidental dislodging. It may require a
strong pull to remove it.

INSTALLING THE BATTERY PACK

• Grasp the pole saw firmly.
• Align the tongue of the battery pack with the cavity.
• Push the battery pack into the handle until the latch locks into place.
• Do not use force when inserting the battery pack. It should slide into position and "click".
Latch
button
14
Fig. 6