Install The Battery Pack - GreenWorks GD24RS Manuel Opérateur

EN
1 DESCRIPTION
1.1 PURPOSE
You may use this product for cutting purposes:
• cutting all types of wood
• cutting plastic
• cutting drywall
• cutting metals
1.2 OVERVIEW
Figure 1.
1 Lock-out button
2 Switch trigger
3 Blade
4 Reciprocating rod
1.3 PACKING LIST
Reciprocating saw
1
Wood blade
2
2 SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3 INSTALLATION
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
5 Shoe
6 Shoe release lever
7 Blade release clamp
Steel blade
3
Manual
4
WARNING
WARNING
WARNING
English
3.2

INSTALL THE BATTERY PACK

Figure 2.
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.3 REMOVE THE BATTERY PACK
Figure 2.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
3.4 INSTALL THE BLADE
Figure 3.
Before you install the blade, remove the battery pack from
the machine.
1. Lift the blade release clamp and hold.
2. At the same time, push the blade to the deepest position.
3. Release the blade release clamp.
Make sure that the blade is tightened. When cutting wet
wood, please clean up the dust and debris near the blade
clamp in time.
3.5 REMOVE THE BLADE
Figure 3.
1. Lift the blade release clamp and hold.
2. At the same time, pull the blade out.
3. Release the blade release clamp.
3.6 INSTALL THE SHOE
Figure 4.
1. Turn the shoe release lever counterclockwise.
2. Push the shoe into the machine.
3. Turn the shoe release lever to original position.
4
WARNING
NOTE
NOTE