GreenWorks ELITE CS-80-XR-T Manuel Du Propriétaire page 11

ASSEMBLY INSTRUCTION
W A R N I N G
If any parts are damaged or missing, do not operate this product until the parts are replaced.
Using a product with damaged or missing parts could result in serious personal injury.
W A R N I N G
Do not attempt to modify this product or create accessories not recommended for use with this
product. Any such alteration or modification is misuse and could result in a hazardous condition
leading to possible serious personal injury.
W A R N I N G
Do not insert the battery until assembly is complete. Failure to comply could result in accidental
starting and possible serious personal injury.
FITTING THE POLE SAW (See Figure 2)
Before using the pole saw, assembly is required. When removed from the box, there are the
three poles as shown below.
• The polesaw head can be mounted directly on polesaw handle so as to achieve the standard
length.
• Connect the polesaw handle to the polesaw head.
• Slide the collar upwards and turn it clockwise until it is completely tightened.
EXTENSION OF POLE SAW (See Figure 3)
The maximum reach can be achieved by fitting the extension tube between the commands rod and
the saw head.
• Slide the collars up and rotate it clockwise until it is completely tightened.
11
Fig.2