EN
4] MOUNTING INSTRUCTIONS
Make sure that there are no pieces missing in the mounting kit. Get the right tools according
to the installation type (Drill, screw drivers, metre tape,...) and follow the mounting
instructions of the CZ3000.
A - Wooden door
A - Wooden door
1
Make a cut on the door leaf and a cut
on the door jamb in order to insert
the magnet and the armature plate
of the CZ3000 magnet. Then mark
the mounting holes of the mounting
screws. Drill the mounting holes of the
magnet and of the armature plate in
order to facilitate the screwing. Drill
the cable access hole.
B - Aluminium door
1
Make a cut on the door leaf and
a cut on the door jamb in order to
insert the magnet and the arma-
ture
plate
of
the
gnet.
Then
mark
holes of the mounting screws and
drill
the
mounting
magnet and of the armature plate in
order to facilitate the screwing.
2
Insert the cable of the magnet. Un-
fasten the screws on the side of the
armature plate (1) with the Allen
key. Mount temporarily the CZ3000.
Then adjust the gap between the
magnet and the armature plate by
adjusting the top screws on the arma-
ture, allow 2mm distance maximum.
Tighten the 2 screws on the side of the
armature plate (2) once the test on
magnet has been successfull.
2
Mount the back plate of the hou-
sing
(note
not
CZ3000
ma-
screws on the side of the arma-
the
mounting
ture plate (1) with the Allen key.
Mount
holes
of
the
Then adjust the gap between the
magnet and the armature plate by
adjusting the top screws on the arma-
ture, allow 2mm distance maximum.
Tighten the 2 screws on the side of the
armature plate (2) once the test on
magnet has been successfull.
Self-aligning Magnetic Shearlock
1
2
1
1
1
2
2
2
that
the
screws
included).
Unfasten
temporarily
the
CZ3000.
CZ3000
3
1
Fasten definitively the magnet on the door.
3
Place the magnet on the back plate of the
are
surface housing as well as the armature on
the
the second back plate of the surface hou-
sing and fasten definitively the magnet on
the door.
2
(x8)
(x8)
(x8)
3