Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Getting Started

Rear Panel

1
23
FM Antenna Terminals
1. Connect the FM antenna to the FM
antenna connector terminal.
2. Slowly move the antenna wire until you find
a location where reception is good, then
fasten it to a wall or other rigid surface.
1
3. If reception is poor, you may need to
install an outdoor antenna. To do so,
connect an outdoor FM antenna to the
FM socket on the rear of the system
using a 75Ω coaxial cable (not supplied).
ONLY FOR SERVICE
• This jack is for testing only. Please do
2
not use.
AUX IN 2 Terminals
1. Use an Audio Cable (not supplied) to
connect AUX IN 2 on the product to Audio
Out on an external analog output device.
• Be sure to match connector colors.
• If the external analog output device has
only one Audio Out jack, connect either
3
left or right.
• Press the TUNER/AUX button to select
AUX 2.
• If the product is in AUX mode for more
than eight hours and no buttons on the
front panel or remote are pushed, the
system will turn off.
4
5
8
English
6
LED Terminals for Speaker Beat
Waving.
4
2.2 CH Speaker Terminals
1. To achieve the correct sound quality,
when you connect the speakers, match
the color of the speaker plugs to the
color of the speaker jacks. See below.
5
• LEFT channel (marked
• RIGHT channel (marked
• Don't force the Purple SUBWOOFER
connector into the White or Red speaker
jack.
Cooling fan
• The fan operates while the unit is
powered on.
If you set the unit to the minimum
6
volume, the fan won't operate.
Secure a minimum 6 inches (15 cm) of
clear space on all sides of the fan when
installing the product.
POWER
7
• Insert only the provided power cable.
7
, White/Purple).
, Red/Purple).

Publicité

Chapitres

Table des Matières

Dépannage

loading

Table des Matières