Jaga Clima Quatro Canal H19 Instructions D'installation page 101

ELECTRICAL CONNECTION DIAGRAM
For general safety information see: warnings and safety -
ALWAYS USE THE MAIN SWITCH TO ISOLATE THE POWER SUPPLY
Standard electrical connection with pre-assembled thermo-electrical drive:
[A], [B] and [C] must be connected in the connection box in the appliance.
The thermo-electric drive(s) are pre-assembled on the valves and also electrically connected to the
left connection block in the connection box.
*JDPC is available as an optional on/off controller based on a water temperature sensor, with a preset
fan speed for heating and cooling.
2-PIPE CONNECTION
ELECTRIC MOTOR
GND
INPUT
[C]
24V
VALVE
4-PIPE CONNECTION
GND
INPUT 24V
[C]
VALVES
24V
[D]
THERMO-
[B]
INPUT
[D]
THERMO-
ELECTRIC MOTORS
[B]
INPUT
[cooling]
[heating]
page 84
On the side of the hydraulic connection,
you can find the box for the electrical
connection too.
0-10 V
GND
0-10 V
GND
24 V
[A]
POWER
GND
24 V
[A]
POWER
GND
101
EN