Babyauto Munoa DS01 Mode D'emploi page 29

7. A harness that is not properly tightened can be
dangerous. Check the harness adjustment and
tighten whenever you put your child in the child
safety seat.
Changing the harness height
8. Place the child on the seat (5.5).
9. Check the height of the shoulder straps for correct
position, the shoulders straps must be thread
through the slots in the cover and seat shell that are
closest to the top of your child´s shoulders (5.6).
10. Adjust the height of the harness, by pressing the
harness adjustment button and pulling the harness
straps towards you to loosen them (5.3).
11. Then unhook one of the harness connector straps
at the back of the seat and pull the loose strap
towards the front of the seat (5.7).
12. Insert the harness strap into the
and backrest at the front of the seat. Then insert
the harness strap into the appropriate upper or
lower slot at the rear of the seat (5.8).
13. Reinsert the harness strap in the harness connector
on the back of the seat (5.7).Then, do the same with
the other harness strap.
IMPORTANTE
Ensure that the belt has no slack.
Group 0/1
J slot of the fabric
www.babyauto.com
EN
29