Important - Babyauto Munoa DS01 Mode D'emploi

5. Fasten the seat belt into the vehicle´s buckle until
it "clicks", making sure the child seat is properly
installed.
6. Tighten the lap belt and diagonal shoulder belt, then
place the red safety clip
belt tongue as near to the vehicle anchor point as
possible without touching it! (3.4, 3.8, 3.9 y 3.10).
Make sure the vehicle's safety belt is not twisted,
also check that the seat cover does not impede the
movement of the vehicle's safety belt or prevent
the installation of the seat in any way. To release
your child unbuckle the vehicle safety belt as
described in the instructions.

IMPORTANT

Ensure that the belt has no slack.
4. INSTALLING CHILD SEAT. GROUP 1.
WARNING
Installing the child seat forward facing can only be maid
if the child is more than 9 kg.
1. To install a Group 1 seat, you must first remove the
padding for Group 0.
2. Pull the metal lever
pull upwards releasing the lever when the stop is
reached (4.1).
3. The seat must be in its most upright position to
adjust reclining angle of the child seat, pull the
control red handle
position is achieved (4.2).
4. Fit this child seat into the vehicle´s seat, making sure
it is firmly pressed against the vehicle seat backrest
(4.3).
Group 0/1
N on the diagonal shoulder
Only suitable for Group 1, approx.
9 months to 4 years of age (9-18 Kg.)
K at the front of the base and
J towards you until the desired
www.babyauto.com
EN
27